[sudo-discuss] Tamale's USB pins fell out D:

[Andrew]

Ohhh Ground! That would explain why we keep baking our pis
On Apr 23, 2013 6:55 PM, "Jae Kwon" <jkwon.work at gmail.com> wrote:

> Just found this thread...
>
> The pins are for serial connections. the USB is just for power.
> (the strange setup is due to the fact that I found out that USB doesn't
> work with long cables, after I set up the USB)
> The doorman.py script uses ttyAMA0 to communicate to the MSP430. So, the
> two pins that were knocked off, should have gone to GRN and UART-TX (serial
> UART transmit pin), wherever those are.
>
>
> On Fri, Mar 22, 2013 at 9:56 AM, Andrew <andrew at roshambomedia.com> wrote:
>
>> I'm confused actually. why where there pins on the raspi being used at
>> all? the serial connection is usb, what else needs to go to the MSP430,
>> power?
>>
>> https://gitorious.org/doorman/doorman
>>
>>
>>
>>
>> On Fri, Mar 22, 2013 at 9:52 AM, <hol at gaskill.com> wrote:
>>
>>> also, i looked into the internal oscillator on the arduino (ATmega328P)
>>> and it should work for I2C or analog stuff but might have difficulty with
>>> TTL serial based on factory tolerances
>>> http://electronics.stackexchange.com/questions/27763/using-the-atmega328-with-the-internal-oscillator
>>>
>>
>>
>>
>> --
>> ---------
>> Andrew Lowe
>> http://www.lostways.com
>>
>> _______________________________________________
>> sudo-discuss mailing list
>> sudo-discuss at lists.sudoroom.org
>> http://lists.sudoroom.org/listinfo/sudo-discuss
>>
>>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://sudoroom.org/pipermail/sudo-discuss/attachments/20130423/774706fb/attachment.html>