[sudo-discuss] cnc mill

[Matthew Senate]

I have two replacement parts, I will bring them by tonight


On Fri, Dec 13, 2013 at 5:55 PM, Hol Gaskill <hol at gaskill.com> wrote:

> the transmission cable that goes from the overhead motor to the spindle
> was disconnected last I looked - might have to track it down.  good luck!
>
>
> Dec 13, 2013 05:47:47 PM, yardenack at gmail.com wrote:
> On Fri, Dec 13, 2013 at 5:35 PM, Jake jake at spaz.org> wrote:
> >> anyone know how to use the CNC mill?  I am thinking of going to sudo
> tonight
> >> to mill something and it would be easier if someone can show me how to
> do
> >> it, rather than figuring it out.
> >> or is there a wiki page for the thing?
> >
> >I know I replied on IRC, but for the benefit of future
> >readers/archivers/crawlers:
> >
> >https://sudoroom.org/wiki/CNC
> >https://sudoroom.org/wiki/O:55
> >https://imgur.com/a/461VK
> >_______________________________________________
> >sudo-discuss mailing list
> >sudo-discuss at lists.sudoroom.org
> >http://lists.sudoroom.org/listinfo/sudo-discuss
> >
> _______________________________________________
> sudo-discuss mailing list
> sudo-discuss at lists.sudoroom.org
> http://lists.sudoroom.org/listinfo/sudo-discuss
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://sudoroom.org/pipermail/sudo-discuss/attachments/20131213/10f7f816/attachment.html>