[sudo-discuss] help with DIY PCB etching?

Mon Jun 13 00:05:39 PDT 2016

Hi folks,

We could use some help with etching a printed circuit board at CCL next
Saturday. Anyone have experience doing this? Any special equipment
available in Sudo?

The goal is not actually to make a PCB, but rather to use the copper traces
of a PCB as a mold to cast silicone rubber on top, to make a microfluidic
circuit.

Thanks!

Patrik
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://sudoroom.org/pipermail/sudo-discuss/attachments/20160613/d81bc092/attachment.html>